Silicon steel cut to length line

1. Automatic cut to length line 2. Two cutter and V notch 3. Width 80 - 320mm

CAH(21)-400D

1. Double/Single head decoiler

Coil ID  500mm

Coil OD 1200mm (Max.)

Coil weight  1.5 T (Max.)

Decoiler speed  Adjust with feeder

Decoiler use synchronization stepless speed regulation with feeding, motor rotation.

2. Guide material buffer device

Use non-pit guide material buffer way, range measuring system, position switches etc.

3. Feeder machine

Make up of Up and down feeding roller and length measurement roller etc, feeder roller drive system adopt drive motion control system. Feed roller adopts polyurethane, normal use 0-180 m/min, highest feeding speed of 240M/min.

4. V punch part

Mainly includes V punch 1 set, servo motor driver.

V notch has horizontal step function, according to the program to automatic adjust.

Punch range: material center of ± 50 mm, stepping series can up to seven levels.

V shear use servo motor drive, high efficiency, low noise.

Knife life: Each grinding can use at less 1 million times

5. Shearing part

Mainly make up of + 45 °shearing machines,  -45 °, shearing machine, horizontal sliding table, discharging roller etc.

Shear use servo motor drive, high efficiency, low noise.

 Knife life  Each grinding can use at less 1 million times

 

6. Discharging platform

Unilateral positioning, transmission belt stepless speed regulation, discharging smoothly.

Discharging motor use Germany ABB motor, Toshiba inverter control.

7. Layered machine

Can complete the upper and lower discharging, mainly make by discharging device, transmission magnetic belt etc.

8. The automatic positioning on unilateral width device

Whole line use unilateral positioning, operation mode adapted to different width transfer. The wide organization adopt linear guide orientation, the ball screw transmission ways

9. Pneumatic system

All pneumatic system use Taiwan AIRTAC pneumatic control system, the structure is compact, pipe is convenient to connect, bus connection.

10. Electric control system

The electric control system includes main electric control cabinet and work station.

 Main technical parameters

1. Rang of work

Thickness  0.23 - ­‌0.35mm

Width  80 - 320mm

Length  500 to 2000mm

2. Require for coil

Width tolerance  ±0.1mm

Burr  ≤0.03mm

S deviation  Between 2000mm ≤0.2mm

3. Precision

Length tolerance  ±0.2mm

Angle tolerance   ±0.025°

Burr   ≤0.02mm

4. Feeding speed  150m/min

1)       Knife life  More than one million (Each grinding) Hard alloy mate

2)       Total installed capacity  About 25Kw

3)       Total gas consumption  1 M3/min

5. Working conditions

(1) Temperature less than 40°C

(2) Voltage fluctuation  380V±10%

(3) Frequency  50Hz

6. Has longitudinal step function

7. Operation table direction  Right to Left, face to the equipment.

  Key components schedule

No.	Name	Qty	Factory or nationality
1	Ac servo drive system	1	Siemens
2	Servo motor	1	Siemens
4	Special motion control module	8	Siemens
5	Programmable controller	12	Siemens
6	Control transformer	1	Siemens
7	Encoder	7	Siemens
8	Miniature cylinder	12	Japan
9	position indicator	2	Germany SIKO
10	Main low voltage electric appliance	1	SCHNEIDER
11	Whole machine manufacture and installation	1	CANWIN

 

                 

Silicon steel cut to length line