Cut to length line machine

1. Cut to length line machine 2. Servo motor shearing 3, Width: 440mm Max 4, Length: no limit

 

  CAH(21)-400D Introduction

1. Double/Single head decoiler

Coil ID 500mm

Coil OD 1200mm (Max.)

Coil weight 1.5 T (Max.)

Decoiler speed  Adjust with feeder

Decoiler use synchronization stepless speed regulation with feeding, motor rotation.

2. Guide material buffer device

Use non-pit guide material buffer way, range measuring system, position switches etc.

3. Feeder machine

Make up of Up and down feeding roller and length measurement roller etc, feeder roller drive system adopt Taiwan DELTA drive motion control system. Center position, feeder can longitudinal whole translation; Double motor drive, using the most advanced servo push-pull institution; Encoder length measurement, servo loop control;

Feed roller adopts polyurethane, normal use 0-180 m/min, highest feeding speed of 240M/min.

4. V punch part

Mainly includes V punch 1 set, servo motor driver.

V notch has horizontal step function, according to the program to automatic adjust.

Punch range: material center of ± 50 mm, stepping series can up to seven levels.

V shear use Taiwan DELTA servo motor drive, high efficiency, low noise.

Knife life: Each grinding can use at less 1 million times

5. Shearing part

Mainly make up of + 45 °shearing machines (can be adjusted fixed for + 90 °), -45 °, shearing machine, horizontal sliding table, discharging roller etc.

   Shear use Taiwan DELTA servo motor drive, high efficiency, low noise.

   Knife life: Each grinding can use at less 1 million times

 

6. Discharging platform

Unilateral positioning, transmission belt stepless speed regulation, discharging smoothly.

Discharging motor use Germany ABB motor, Toshiba inverter control.

7. Layered machine

Can complete the upper and lower discharging, mainly make by discharging device, transmission magnetic belt etc.

8. The automatic positioning on unilateral width device

Whole line use unilateral positioning, operation mode adapted to different width transfer. The wide organization adopt linear guide orientation, the ball screw transmission ways

9. Pneumatic system

All pneumatic system use Taiwan AIRTAC pneumatic control system, the structure is compact, pipe is convenient to connect, bus connection.

10. Electric control system

The electric control system includes main electric control cabinet and work station.

  Use Taiwan CNC motion control dedicated system,can realize multi-axis synchronization movement,realize complex shearing demand; Human interface design, easy to use,powerful,speed governing,positioning and function control are made up of Taiwan DELTA AC servo system,Taiwan DELTA logic control system, etc. Speed is above the normal movement 10 times, realize unprecedented high speed and high precision shear.

      Independent development of control program, and sheet shape shear program can be carry out all the tasks shear.

    

u   Main technical parameters

1. Rang of work

Thickness 0.23 to  0.35mm

Width 80-440mm

Length  500 to 2500mm

2. Require for coil

Width tolerance   0.1mm

Burr  ≤0.03mm

S deviation  Between 2000mm ≤0.2mm

3. Precision

Length tolerance  0.2mm

Angle tolerance  0.025°

Burr  ≤0.02mm

4. Feeding speed  150m/min

1)       Knife life: More than one million (Each grinding)  Hard alloy mate

2)       Total installed capacity   About 25Kw

3)       Total gas consumption  1 M3/min

5. Working conditions

(1) Temperature less than 40°C

(2) Voltage fluctuation: 380V10%

(3) Frequency   50Hz

6. Has longitudinal step function

7. Operation table direction  Right to Left, face to the equipment.

                                  

Cut to length line machine